The home of fire protection engineering software, designed
and sold by fire protection engineers.

 
Fire Pump Evaluation Program 2002 Revisions

Build #

Table

Changes

  

  

  

6

Test

Added [Transfer SW Tested] (B)
Added [Transfer Time] (N)
Added [Peak Flow Time] (N)

7*

Pump

Test

Flow

Added [Trans Sw Loc] (A40)

Deleted [Transfer Sw Tested] (B)
Renamed [Transfer Time] (N) --> [Retransfer Time] (N)

Renamed [Company ID] (A40) --> [CompanyID] (A40)
Renamed [Location ID] (A40) --> [LocationID] (A40)
Renamed [Pump ID] (A30) --> [PumpID] (A30)
Renamed [Test ID] (A20) --> [TestID] (A20)

*requires conversion program to go from Build 6 to Build 7

8

  

Discharge Pressure Location print out fixed
Pressure Gauge Calibration Date print out fixed
Relief Valves print out fixed
Transfer Switch Location print out fixed

9

  

Reordered printout sections under Pump
Added Flow Points printout
10   Fixed Pressure Gauge Calibration Date print out truncation
11  

Rewrote Backup and Restore units
Upgraded ZipForge 1.3 to 2.66

Click here to download the latest revision.
The downloaded program file "FPEP2002.exe" should be used to overwrite the
existing program file that can be found in:  "C:/Program Files/FPE Software/FPEP 2002"

IMPORTANT
This file can only be used to update Builds 7 through 10.
To determine your Build number, run FPEP2002, click on Help, then click on About.
The Build number will be displayed next to the Version number.

This file CAN NOT be used to install the program.  It will not run alone.

 
 
Copyright 2005 FPE Software, Inc.